Wide mount / holder for DM4 microscope

Prints needed: one DM4holder, two DM4holderside

Parts needed:
- two 50cm (or any sensible width you desire) M8 threaded rods - I bought an 1 meter rod that i cut in half (but this needs some handyness with metalworking).
- 8 nyloc M8 nuts and spacers (technically i guess both them being nyloc and the spacers are optional)
- optionally 4 M8 nuts to hold the middle part in the middle
(plus maybe a couple of M8 nuts to hold the threaded rod steady when turning the nylocs into place)

I also suggest cutting square felt pads (or similar) for the "legs".

The DM4holder part has a hole to be tapped for an M4 screw to hold the scope better, but it ended up being a snug fit without, so that is untested/unused in mine.
A lot in the code could be improved, but this was the first prototype and it all ended up being good enough to work, so i'm posting it as-is.


(WIP tag is there to indicate poor code quality, but i'm unlikely to make any big or incompatible changes to the actual pa