Thingiverse
Wii U stand
von capitaenz
427
Downloads
345
Likes
18
Makes
This is a simple stand for Wii U.
Created in less than 30 minutes with a scanner, Inkscape and Sketchup.
So far I have not printed the stand or tested on my Wii U.
The most important dimensions were checked.
This part is not sold separately from Nintendo!
Update: 07.01.2013
New version. Foam rubber can be used now as the original. WiiUstand v2
Someone has already printed?
Update:
Pnit has printed it and it fits!
The status "Work in Progress" was removed.
Created in less than 30 minutes with a scanner, Inkscape and Sketchup.
So far I have not printed the stand or tested on my Wii U.
The most important dimensions were checked.
This part is not sold separately from Nintendo!
Update: 07.01.2013
New version. Foam rubber can be used now as the original. WiiUstand v2
Someone has already printed?
Update:
Pnit has printed it and it fits!
The status "Work in Progress" was removed.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
