Thingiverse
Wilson II - 8mm version
von twystneko
14
Downloads
10
Likes
0
Makes
This is a remix of the Wilson II printer, to convert it to using 8mm rods and bearings. I've also added ziptie channels to the X-Carriage.
The Z Top and Motor files should be mirrored, your slicer should be able to do that.
You will need all the other files from the Wilson II - this is just the files I've edited.
The file "sunhokey_belt_clip.stl" is designed to fit the Sunhokey 2015 bed, so it can be used with the printer. It has built-in support. Just use a razor blade to separate it. It should pop off.
The Z Top and Motor files should be mirrored, your slicer should be able to do that.
You will need all the other files from the Wilson II - this is just the files I've edited.
The file "sunhokey_belt_clip.stl" is designed to fit the Sunhokey 2015 bed, so it can be used with the printer. It has built-in support. Just use a razor blade to separate it. It should pop off.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
