Wilson IIK

Update 22 April 2018
Added just a smidgen more clearance for the XY joiner to address tolerance issues.

Updated 20 Feb 2018
Reworked box for MKS Gen L (I had the holes slightly off.
Lid now comes with hole for 60mm fan and a version without (cut your own.)

Spool Holder finished.
You will need a short section of threaded rod and an assortment of bearings, nuts washers etc. See pic for assembly (left to right in photo.)

---------------------------------------------------------------------------

First off, this variant would not have happened without the fantastic design by Mrice.

My main motive was two fold. First to make alignment of the Y-Axis stiffer and easier to assemble. Second to clean up the rat’s nest that was my first Wilson II build (See last picture, I’m so ashamed!) LOL.

The main changes were to the Y-axis and how it mounts to the main frame.
A warning, at around 80% infill the set will take the better part of a spool to print out all the pieces. W