Thingiverse
winch line stop
von NikDFish
2
Downloads
3
Likes
1
Makes
I needed a line stop for a winch I was updating with synthetic cable. This is intended for use with 3/16" - 5/16" cable. Assembled, it is 61mm across (2.4") and 51mm thick (2").
I printed it in TPU using 50% infill. The two halves are joined with 5mm cap head screws (18mm long) & nuts.
I printed it in TPU using 50% infill. The two halves are joined with 5mm cap head screws (18mm long) & nuts.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
