Winch mount for SCA-1E

This riser will fit the existing holes on the carisma big bumper which is included as an option in the SCA-1E Tacoma. It allows you to mount the Injora 1:10th winch.
You will need 8 2x8mm screws and 4 - 2mm nuts.

The nuts will go into the outside holes and should be pulled in prior to installing the winch.
I just screwed them in and tightened the nuts down until they sunk just below the top surface.
After installing the nuts you need to remove the screws, attach the winch to the plate, and then attach the assembly to the bumper using the remaining 2mm screws.


https://a.co/d/0eAl6cg - winch
https://a.co/d/cxMX9L0 - controller which allows you to use your RC TX to control the winch.