Thingiverse
Wind 5 Ghost QT mount
von Kaymen219
1
Downloads
3
Likes
0
Makes
ImmersionRC Ghost Antenna Mount for the HGLRC Wind 5 Lite Frame.
Designed in Fusion 360 and Printed on Ender 3.
This is a tight fit to get it in the slot. Be careful bending the antennas, I typically put the top of the "T" in first then slip the lead to the receiver through the bottom of the "T" then rotate the plastic of the QT 90 degrees into position.
Designed in Fusion 360 and Printed on Ender 3.
This is a tight fit to get it in the slot. Be careful bending the antennas, I typically put the top of the "T" in first then slip the lead to the receiver through the bottom of the "T" then rotate the plastic of the QT 90 degrees into position.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
