Thingiverse
Wind Gauge with direction indicator
by bportelalpz
157
Downloads
120
Likes
0
Makes
A wind gauge with direction indicator.
Need one 8x22x7mm bearing (608 or similar, like skateboard bearings) and one 7x22x7 bearing (627 or similar, I use one from a fidget spinner)
Need some glue between "Base" and "eje" and between each "pala" and "cabezal".
There are two versions of base part, print only one. The first one is allowed to use with a 8 mm rod (Base_8mm_Rod.stl, not tested) and another one to use with a 15x30mm wood strip (Base_15x30_table.stl), like in the pictures.
"Capuchon" part is optional, and it is designed to prevent water into the 608 bearing. It snaps onto shaft.
Need one 8x22x7mm bearing (608 or similar, like skateboard bearings) and one 7x22x7 bearing (627 or similar, I use one from a fidget spinner)
Need some glue between "Base" and "eje" and between each "pala" and "cabezal".
There are two versions of base part, print only one. The first one is allowed to use with a 8 mm rod (Base_8mm_Rod.stl, not tested) and another one to use with a 15x30mm wood strip (Base_15x30_table.stl), like in the pictures.
"Capuchon" part is optional, and it is designed to prevent water into the 608 bearing. It snaps onto shaft.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
