Wind speed gauge - Anemometer

Major update!!
use V3 at: https://www.thingiverse.com/thing:4854046

V1 and V2 are harder to print but did hold up quite well, but v3 has vast improvements.

Another Update 5/4/2019:
I've added another sleeve to hold a bearing for faster spinning gauge. File windspeed12-base-bearingholder.stl I've also swapped to petg just to test and so far its done about the same as ABS. With this I've recorded winds of just over 55mph. I've also updated the schematics.

This is ONE piece of my weather stations. This Anemometer works fantastic and has handled and recorded winds up to 50+mph so far. It is made to slide into PVC pipe. I use a simple op amp circuit to convert infrared LED and infrared transistor to a digital signal. The digital signal is recorded by ESP8266 12E. Then sent to local network and off sight server. I've put a link to the full weather station schematics below. Hope they are useful. Sight were my weather station reports to is http://shermluge.xyz/wx

This is still v