Thingiverse
Wind turbine Sci-fi terrain
von Runoved
69
Downloads
87
Likes
1
Makes
Wind turbine as terrain for your wargame. Can be used for both standard 28mm scale games and 1/285 scale games such as battletech. The wind turbine is available in two versions, stationary and rotating.
To make a stationary version, just print and assemble two parts: "Rotor02_1" and "Base02_Solid".
To make a rotating version you need to print the following parts: "Rotor02_1", "Base02_Rotating" and "Axis01". You will also need two size 608 bearings. You can use ready-made ones or print these, for example:
https://www.thingiverse.com/thing:4628063,
https://www.thingiverse.com/thing:4821342
The assembly sequence for the rotating version is as follows:
-Place bearings on both sides of the axle;
-Insert the axle with bearings into the rotor with the triangular end;
-Install the resulting assembly into the base.
All parts are printed without supports, with the exception of the rotor, which may need support in the hole for attaching the axle.
I
To make a stationary version, just print and assemble two parts: "Rotor02_1" and "Base02_Solid".
To make a rotating version you need to print the following parts: "Rotor02_1", "Base02_Rotating" and "Axis01". You will also need two size 608 bearings. You can use ready-made ones or print these, for example:
https://www.thingiverse.com/thing:4628063,
https://www.thingiverse.com/thing:4821342
The assembly sequence for the rotating version is as follows:
-Place bearings on both sides of the axle;
-Insert the axle with bearings into the rotor with the triangular end;
-Install the resulting assembly into the base.
All parts are printed without supports, with the exception of the rotor, which may need support in the hole for attaching the axle.
I
Runoved veröffentlicht auch auf
6 zusätzliche Modelle auf 1 weiteren Plattformen
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
