Thingiverse
Wind Turbine
von tomrib01
0
Downloads
2
Likes
0
Makes
This is a wind turbine model I created using Solidworks. I sliced all the parts on cura and printed them with my ender 3. I then glued all the pieces together.
The only way i could print the blades was with surface mode. I also used a raft for them to stick to the bed.
The blades and the hub don't fit properly but it's good enogh for a first design.
In the future I will probably make all parts with connectors so no glue will be neede
The only way i could print the blades was with surface mode. I also used a raft for them to stick to the bed.
The blades and the hub don't fit properly but it's good enogh for a first design.
In the future I will probably make all parts with connectors so no glue will be neede
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
