Slicer Discord
Wind turbine V4 – Modelo 3D imprimible de Thingiverse Thingiverse

Wind turbine V4

por _Maxim3D_
104 Descargas
78 Likes
0 Makes
Ver Modelo
I have build this turbine with the objective to produce electricity to charge small devices like smartphone or powering a led strip.
I can't use solar panel because my balcony is lit by the sun 4 hours per day. But luckily for me, i live near the sea and there is constant wind which coming with the tide, so i decided that building a wind turbine can be a good alternative.

This wind turbine is pretty reliable and robust, it survive many storms (wind > 110km/h !) with little damage (some nuts tend to loosen, they were remplace by nyloc).

https://www.youtube.com/watch?v=v8p_QvocnHA

This wind turbine starts with wind speed of 3m/s (approx .10km/h) with no load.
The measured torque on the shaft is approximately 0.25N.m at 20km/h wind. I think is sufficient to move a stepper motor to produce some electricity but it will increase the wind speed at which the turbine starts.

I am using stepper motor from Digikey (ref 1528-1062-ND) as generator and a full bridge rectifier to produc
Fuente
Thingiverse
Lo que necesitas para imprimir: Intermedio Baja confianza
Pieza única Tornillería requerida
Soportes 1/3
Ensamblaje 0/3
Ajustes 1/3
Tamaño de cama 0/3
Postproceso 1/3
Impresora
FDM / FFF
Formato de archivo
STL
Material
PLA
Tiempo estimado
4 h
Postprocesado
Tornillería
Software
Cura, PrusaSlicer o similar
Aún no hay valoraciones
Aún no hay comentarios – ¡sé el primero!

Modelos similares

6 Sugerencias
Feed Blog Slicer Calculadora Búsqueda por imagen Enviar Contacto Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Añadir a colección