Thingiverse
Winder cable tidy (6 sizes)
von splabble
5.2k
Downloads
3.5k
Likes
3
Makes
### What's this?
Wind up cables, string or ropes of all lengths and sizes with this simple print.
6 different sizes included from 60mm to 126mm (distance between tips of the prongs).
### How to print
I used a 0.3mm layer height, 40% infill and no supports.
Printed vertically as shown in the render, however I'm sure it would also work on its side without supports (this may also be a bit stronger due to the layer orientation).
The photos show the largest 126mm winder.
Two versions of the winders are included: one set of STL files with screw holes (numbered 1 through 6) and *All sizes WITHOUT screw holes.stl* which contains the same 6 winders but screw holes removed (so you can add your own, glue them to something etc).
The screw holes have a diameter of 5mm + a 2.5mm chamfer.
Wind up cables, string or ropes of all lengths and sizes with this simple print.
6 different sizes included from 60mm to 126mm (distance between tips of the prongs).
### How to print
I used a 0.3mm layer height, 40% infill and no supports.
Printed vertically as shown in the render, however I'm sure it would also work on its side without supports (this may also be a bit stronger due to the layer orientation).
The photos show the largest 126mm winder.
Two versions of the winders are included: one set of STL files with screw holes (numbered 1 through 6) and *All sizes WITHOUT screw holes.stl* which contains the same 6 winders but screw holes removed (so you can add your own, glue them to something etc).
The screw holes have a diameter of 5mm + a 2.5mm chamfer.
splabble veröffentlicht auch auf
7 zusätzliche Modelle auf 2 weiteren Plattformen
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
