Window Blind Rail Hold Down Bracket

This is a remix of the bracket made by bah2830

I'm using this on a back door that gets used a lot so I printed it in PETG for the added strength, but PLA would probably work fine.

Due to the increased rigidity it is a little more difficult to get the bottom rail of the window blinds in place, so this is probably not ideal if you take that part out often.

Changes I made:

Increased the retainer pin thickness to 3mm
Increased base thickness to 3mm
Added a beefier angle support with taper to avoid contact with screws
Reshaped the back of the vertical to make it thicker with an angular structure to increase strength and stability
Screw holes are now 4mm wide and 10mm apart at their centerline