Window Filler Parametric

4/25/26 Update ⚠️ Important before you go further this model includes the V1 hole component and the V2 hole component. These hole sections are different dimensions so make sure you are using the correct model for your application. The 3 filler pieces are the same and attach to the V1 and V2. Print the component with the hole using 4 wall loops and 25% gyroid infill. This provides sufficient material for the heat set inserts to bond securely while minimizing the risk of deformation. The remaining components may be printed with 8–10% infill and 3 wall loops; however, 2 wall loops may be sufficient if the infill percentage is increased slightly.The model orientation has been corrected in Fusion 360, so files downloaded from the model generator should already be properly aligned to the build plate for printing. Refer to the guide below to verify proper orientation before printing. Incorrect orientation may result in print failures or excessively tight dovetails. Only the component with the