Thingiverse
Window screen sifter / strainer
von MIlmoWK
7
Downloads
4
Likes
0
Makes
Print base, do not remove from build plate.
cut screen into a 5.5" circle, add to base with a few dabs of super glue to hold it temporarily.
print top piece in the same orientation with a 3.5mm z offset of home machine on center of first part.
I had good results printing the first layer of the top part at 125% extrusion and +10°C
i used fiberglass window screen which measured ~.4mm thick.
cut screen into a 5.5" circle, add to base with a few dabs of super glue to hold it temporarily.
print top piece in the same orientation with a 3.5mm z offset of home machine on center of first part.
I had good results printing the first layer of the top part at 125% extrusion and +10°C
i used fiberglass window screen which measured ~.4mm thick.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
