Windshield Wiper Pin Clip

I have pin style mounts on the windshield wipers for my car. The Rain-X wipers that I have on the car are fine, but the dumb spring clip that holds them on the pins are weak and one of them broke within two months of installing the wipers. The diameter of the small section of the pin on my car is 6.29mm.

I designed this and printed with 4 perimeters, 50% infill (rectilinear) and .15 mm layer height. It printed in 8 minutes on my Prusa i3 Mk 3s+. I printed it out of PETG and it has worked great!

The cost of the filament was 2 cents and the price to replace the wiper would have been $24.99 at the local auto parts store

*** NOTE *** I did cut the old weak spring clip off prior to installing this piece.