Thingiverse
Windshield Wire Clip
door theCoolTinkerMan
11
Downloads
7
Likes
0
Makes
This project is one of my first experiences with a 3D printer. I wanted to mount a wiper motor on the polished aluminium windshield frame shown in the pictures.
Mounting the wiper motor by itself was not the problem, but running wires to the motor was!
Once the glass was installed, I had to device an easy and simple method of routing the wires from under the dash to the motor, over the windshield frame.
This is the first version of my design - the project has been posted at http://www.instructables.com/id/A-Set-of-3D-Printed-Windshield-Wire-Clips/
Mounting the wiper motor by itself was not the problem, but running wires to the motor was!
Once the glass was installed, I had to device an easy and simple method of routing the wires from under the dash to the motor, over the windshield frame.
This is the first version of my design - the project has been posted at http://www.instructables.com/id/A-Set-of-3D-Printed-Windshield-Wire-Clips/
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
