Wine Bottle Corker Set
by JayGriffith
14
Downloads
9
Likes
0
Makes
This was my take on a wine bottle corker set. The outer sleeve was designed to sit on the lip of the bottle (roughly 30mm) and the inner funnel allows the cork to compress into the size of the opening (roughly 18mm). The upper hole is built for 1" (25mm) diameter corks.
The cork fits into the upper opening of the sleeve and the driver sits on top of it. The driver is then struck with a hammer or mallet and this forces the corker through the funnel and into the neck of the bottle. Once the cork is pushed through the outer sleeve, you can remove the sleeve and strike it once more with the drive to finish it off. This gets the cork completely into the neck.
When I was making my test pcs, my printer failed prat way through the outer sleeve. The failed part still functioned as intended and so I made it an alternative option for a shorter print time.
The cork fits into the upper opening of the sleeve and the driver sits on top of it. The driver is then struck with a hammer or mallet and this forces the corker through the funnel and into the neck of the bottle. Once the cork is pushed through the outer sleeve, you can remove the sleeve and strike it once more with the drive to finish it off. This gets the cork completely into the neck.
When I was making my test pcs, my printer failed prat way through the outer sleeve. The failed part still functioned as intended and so I made it an alternative option for a shorter print time.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
