Thingiverse
Wine rack support
by Joepro19
0
Downloads
0
Likes
0
Makes
Made this to hold my wine rack vertically. (see pdf for picture) Could also work to hold it horizontally.
I made 2 to make sure it would be solid enough to hold the weight. Been holding up for almost 6 months. Be sure to load the rack from the bottom.
Printed on the side without support (see picture)
Printed in PLA infill 100% but could be stronger in PETG.
I made 2 to make sure it would be solid enough to hold the weight. Been holding up for almost 6 months. Be sure to load the rack from the bottom.
Printed on the side without support (see picture)
Printed in PLA infill 100% but could be stronger in PETG.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
