Wine Stopper Display Storage Rack

It is what what the title says.

You'll need to print two risers, one base plate and one top plate. No supports are needed if you print in the orientation of the included STLs. I've tested it on a variety of stoppers to be sure it fits. The holes that the stoppers rest in is tapered to keep them standing straight up.

The risers are attached to the base with countersunk M4 screws. 10-40mm length is fine. You can also attach the risers with some glue instead, but be sure to seat the top plate in to the risers first so they sit properly while the glue dries.

The top plate simply fits in to the risers with no attachment method necessary as they are nice and snug. You can add a dab of glue if you want, but I did not find it necessary.

The base is 260mm wide, so you'll need to angle it at about 45 degrees on the bed and then somewhat tediously move it around a little in order for it to fit. Be patient, it definitely fits on a 250x210 bed. I'd suggest a brim on the bottom p