Wing Guard (2 layer thick)

This is a remix to accommodate a two layer thick trailing edge. I'm using it on my HB1 build: https://www.thingiverse.com/thing:3903714My wing already took some damage, so hopefully this will help preserve it further. A new wing should have less wear and tear with this in place.I printed at 100% infill with PolyMax PLA, which is tough, but has a tendency to flex a bit before breaking.For a snugger fit, print at 90-97% scaleLink to original file: https://www.thingiverse.com/thing:2549633 Want to support my work for free?Check out Amazon for your hobby supplies(as an affiliate, I earn a small commission if you buy from Amazon, but there is no extra cost to you)Print SettingsPrinter Brand:Raise3DPrinter: N2Rafts:NoSupports: NoResolution:100Infill: 100Filament: PolyMaker PLA+ Black Category: R/C Vehicles