Wing Guard (2 layer thick)

This is a remix to accommodate a two layer thick trailing edge. I'm using it on my HB1 build: https://www.thingiverse.com/thing:3903714

My wing already took some damage, so hopefully this will help preserve it further. A new wing should have less wear and tear with this in place.

I printed at 100% infill with PolyMax PLA, which is tough, but has a tendency to flex a bit before breaking.

For a snugger fit, print at 90-97% scale

Link to original file: https://www.thingiverse.com/thing:2549633

###Want to support my work for free?
**Check out [Amazon](https://amzn.to/3ZOvYVI) for your hobby supplies**
(as an affiliate, I earn a small commission if you buy from Amazon, but there is no extra cost to you)