Thingiverse
Wingsail for autonomous USV
door Bazmundi
2
Downloads
3
Likes
0
Makes
Just starting toying with a USV based upon a wingsail design.
Based upon hint I found that NACA 4 point is a good start. Especially NACA 00018.
Only just starting out.
It is 120mm cord and sections 100mm in height.
A 16mm OD carbon fibre tube will be used as "mast" (and to provide a means to rotate).
5mm OD carbon fibre tube for booms.
Size, of course, dictated by print volume of my Flashforge Finder.
Sail can then be in increments of 100mm.
Based upon hint I found that NACA 4 point is a good start. Especially NACA 00018.
Only just starting out.
It is 120mm cord and sections 100mm in height.
A 16mm OD carbon fibre tube will be used as "mast" (and to provide a means to rotate).
5mm OD carbon fibre tube for booms.
Size, of course, dictated by print volume of my Flashforge Finder.
Sail can then be in increments of 100mm.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
