MyMiniFactory
Toys & Games
Go to Model
Winterwing Butterfly Flexi
0
Downloads
1
Likes
0
Makes
STL/3MF Multicolor Regular eyes/ 6mm eye sockets Print Settings: 2 parts - wings and body No Supports needed Arachne walls 2-3 walls 5-10% infill Test printed to 70% YMMV If you have adhesion issues, try a brim, glue stick or Aquanet hairspray ***Winterwing butterfly wings would benefit from lower layer heights, and at this size - ironing helps too (Just make sure not to iron the body too like I accidentally did). The snowflakes in the wings are quite thin in some areas so it isn't a bad idea to scale up higher; just remember to scale body and wings the same. Add a teeny dab of glue on the flat base around the peg and peg sides, then push the body on. Try not to add too much as there are joints (leg) around this area. If it is too tight due to filament expansion, shave the peg down some.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
