Wio Link Case

Wio Link + Battery Compartment

Materials Needed:
4pcs M3 screws with nut

Optional:
Double sided tape to hold the battery

v.1.1

The cover has .5mm spacing on all sides from the base. The Wio Boards was not gonna fit, you need to cut or file on some edges inside the case to fit the wio board. You will need 4 M3 screws to mount the board at the cover (facing down). This is a work in progress version, i did not recommend printing it.

v.1.2

> The .5mm spacing was removed to make the cover fit on the base.
> Made some adjustment inside the case so the Wio board should fit without post printing adjustments.
> Vent holes was replaced by open hardware logo.
> Minor improvements in USB, Grove Connector holes
> Adjust battery wire way