Thingiverse
Wire Clip
by Petal3D
0
Downloads
6
Likes
0
Makes
I needed to clip electroluminescent wire onto the edges of a sign made from 5mm corflute.
If required, scale the clip to suit your sign thickness.For best strength, print using a filament printer with a side against the print bed. Supports are not required.
Use hook-and-loop tape to attach the battery unit to the rear of the sign. Run the electroluminescent wire around the edges and clip in place. For a more permanent attachment, use double-sided tape to hold the clip in place.
If required, scale the clip to suit your sign thickness.For best strength, print using a filament printer with a side against the print bed. Supports are not required.
Use hook-and-loop tape to attach the battery unit to the rear of the sign. Run the electroluminescent wire around the edges and clip in place. For a more permanent attachment, use double-sided tape to hold the clip in place.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
