Wire Connectors (Quick Connect/Disconnect)

Wire Connectors
===

The idea is to make a usable wire connectors that only consists of wires and 3D printed connectors. No other pieces.

### Tried to make them according to these specifications:
* Ease of assembly
* This is the third version I designed from scratch. Some prototypes seemed like good ideas, but after printing, I realized there was no easy way to put it together or insert the wires. These are ok.
* Small Size
* They're larger than standard wire connectors, but still small enough.
* Reliability of connection
* Going to need to test this. Work in Progress.
* Ease of Printing
* There are small features so the first layer has to be printed very slowly to stick properly. Also if the first layer has elephant foot, the edges might have to be trimmed slightly to allow fitting.
* Low risk of shorting
* Should be unlikely. The only scenario is where the the wire strands are loose. If you twist tightly or lightly solder them, shouldn't happen.
* No other