Wire Hanger Wrangler

I hate it when I'm hanging up shirts from the dryer and I reach for a hanger on the rod, and I pull half a dozen down in a huge tangle, and wind up flinging half of them across the room.

This is my attempt to beat them back into submission, and with reasonable care, it works pretty well at dispensing only one hanger at a time. I threw in the "reasonable care" qualifier there because my rough-and-ready overly-helpful husband managed to nearly break the first one by trying to snatch a handful of hangers at once. (Not recommended, but he still gets husband points for hanging up his own shirts!)

Revised (husband proof?) design has been strengthened a bit and the holder angle slightly increased to keep the weight of the hangers from pulling down the lower rod slightly when it's fully loaded. (Prints just fine without support.)

Can be mounted on a block for horizontal dispensing, or on a wall right over the dryer. (If you line up several hangers at the hook, you can load several