wire Kitchen hanger slim

Traditional wire kitchen hangers
My wife uses it for the handle of T-fal.
(´ ・ ω ・ `)>
It's different from the intended use, but I think this is fine.
However, this shape is prone to breakage, poor fixing, and it was too complicated to make because it needed an auxiliary material after all, so I redesigned it.
The base of the wire kitchen paper holder has good fixation and stability, so I decided to recreate it as a basic design in the future.
First, review the wire kitchen hanger.
The width is 1.4 mm.
PLA + arrives
I printed it.
Since there is no problem with lightweight items, the load and shape are slimmed down.
I think it's enough.
However, since it is PLA +, it takes about several months if it is related to drying and frequency of use.
Consider the use of
Prepare for mass printing.
従来のワイヤーキッチンハンガーは
妻がT-falのハンドル用に使っている。
(´・ω・`)>
考えていた用途と違うが、これはこれで良いかと思う。
しかし、この形状で破損が発生しやすい、定着が悪く、結局補助材が必要だったのと作成があまりにも雑だったので、再度設計してみた。
ワイヤーキッチンペーパホルダーのベースは定着と安定性が良いのでこれを基本設計として今後すべ