Thingiverse
Wire Loom Guide
von Mikey13
10
Downloads
3
Likes
0
Makes
Wire loom guide designed to be installed without removing wires just slide the wires in the slot then twist 90degrees and your wires are now captured and ready to be managed just add a little adhesive i.e. hot glue or double stick tape to the base and your ready to go! Model should be printed with the solid side on the build plate with supports, everything other setting is up to your liking, i also have another version with a wider base for better adhesion capabilities
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
