Wire Management Guides

These are some wire management guides which I designed to use with my Voron 2.4 build. They use thin zip ties to help secure wires and there is a version which is designed to bridge over a DIN rail. I am using them to secure the ground wires to my DIN rails. Since these models are designed to work with electrical components (wires), if you use these models, it is at your own risk. These models will not meet code requirements, so use your best judgement if they should be used in your application or not. If unsure, consult an expert or professional (not me). In general, I suggest using a flame retardant filament for any prints that will hold electronic components. All but two of these guides are designed for two wires (side by side). There are two single wire versions which I designed to allow me to connect ground wires to my DIN rails on my Voron 2.4 build:WIRE_GUIDE_90DEG_30MM_4F.stlWIRE_GUIDE_90DEG_58MM_4F.stl These versions have a 90 degree bend and a tab, which fits under the DIN ra