Wire Spool Holder Gridfinity (Printed Fasteners)

firstgizmo created the original design for this wire spool holder. DJR Engineering added some really great features and changes. I took DJR Engineering's design and re-added the 3D printed fasteners that firstgizmo used in their design. These fasteners work quite well, and it avoids the need to have the otherwise required M3 machine screws. I also enlarged the center hex hole in the spool slightly so that a ¼ inch hex bit can be used to drive them. This lets you use any random ¼ inch bit to drive the spool, even if it is actually a philips, torx, flat, etc driver bit. These bits are the common standard size, at least in the US. Change List from DJR Engineering's ModelThreaded fastener holes cut into the support pieces that previously had holes for an M3 machine screwEnlarged the center hex hole in the spool slightly so that any ¼ inch hex tool can be usedAdded the flat bolt fasteners from firstgizmo original design (unmodified)Added the side panels from firstgizmo original desi