Thingiverse
Wire Wall Mount / Holder / Clip
von TNG_Robotics
39
Downloads
48
Likes
0
Makes
Wall wire mount / holder / clip that uses small 2 nails into standard drywall or wood. This is for smaller wires to help manage their placement on walls. I originally designed it to hold cords for my plant lamps up the wall.
It will print under most setting just fine, but recommend rotating 90 degrees and printing on its side. Used infill of 15%, layer height of 0.175 mm, raft not needed.
Dimensions: 30 mm length x 10 mm width x 8 mm height
Wire holder area: 10 mm length x 5 mm height
It will print under most setting just fine, but recommend rotating 90 degrees and printing on its side. Used infill of 15%, layer height of 0.175 mm, raft not needed.
Dimensions: 30 mm length x 10 mm width x 8 mm height
Wire holder area: 10 mm length x 5 mm height
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
