Thingiverse
Wireframe Sphere Ornament
por marcoalici
7
Descargas
6
Likes
0
Makes
A new ornament for christmas trees and house decoration. It's made using Ø1.75 mm filament to create the wireframe part of the sphere.
**INSTRUCTIONS**
1. Choose the diameter of the sphere (100mm or 60mm);
2. print the relative TOP and BOTTOM parts;
3. Cut 8 pieces of filament (1.75mm):
* 145 mm long for Ø100 mm sphere
* 87 mm long for Ø60 mm sphere
4. Insert one end of the filaments into the 8 holes of the TOP part (if too tight, pass a 2 mm drill bit into the holes to clean)
5. Insert the other end of the filament into the 8 holes of the BOTTOM part.
Done!
**INSTRUCTIONS**
1. Choose the diameter of the sphere (100mm or 60mm);
2. print the relative TOP and BOTTOM parts;
3. Cut 8 pieces of filament (1.75mm):
* 145 mm long for Ø100 mm sphere
* 87 mm long for Ø60 mm sphere
4. Insert one end of the filaments into the 8 holes of the TOP part (if too tight, pass a 2 mm drill bit into the holes to clean)
5. Insert the other end of the filament into the 8 holes of the BOTTOM part.
Done!
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
