Slicer Discord
Wireless charger dock – 3D-Druckmodell von Thingiverse Thingiverse

Wireless charger dock

1 Downloads
0 Likes
0 Makes
Zum Modell
Wireless charger dock for smartphone.

Tested with a S20+ with a OtterBox Defender case (increaste the height a little bit), but can be used with other Samsung models.

The wireless charger I used is the IKEA LIVBOJ and an IKEA Usb C-C cable, I don't know if it can fit other wireless chargers/charging cables, so i just increaste the width so it may fit with other USB C cables.

I have made the measurements from a previous version that I have printed and I had to adjust them because they were too small to put the charger and cable so this version can be either large or a little tight for the wireless charger to be embedded and avoid play or can be detached when not charging.

If you see that the hole where the wireless charger is placed is too tight, you can sand it with 200 grit sandpaper or less to reduce and adapt it to the right size (do not sand it too much or the charger may be too loose.

The bracket on the back is a different size from where it fits on the base, so you
Quelle
Thingiverse
Was du zum Drucken brauchst: Mittel Niedrige Konfidenz
Einteilig
Supports 1/3
Zusammenbau 0/3
Einstellungen 1/3
Druckbett 0/3
Nachbearbeitung 1/3
Drucker
FDM / FFF
Dateiformat
STL
Material
PLA
Nachbearbeitung
Schleifen
Software
Cura, PrusaSlicer o. Ä.
Noch keine Bewertungen
Noch keine Kommentare – sei der Erste!

Ähnliche Modelle

6 Vorschläge
Feed Blog Slicer Kostenrechner Bildersuche Einreichen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Zur Sammlung hinzufügen