Slicer Discord
Wireless charger stand – 3D-printbaar model van Thingiverse Thingiverse

Wireless charger stand

door Kisssys
4 Downloads
2 Likes
0 Makes
Model downloaden
I have an old Samsung J7 that didn't come with a wireless charging receiver built it. I added a Qi wireless charging pad and use a Choetech T511-S charger. It has been great to not have to plug that little micro usb connector in all the time. I have also converted some of my old readers to wireless and decided to make a stand for my Fire HD8 to set by my bed. I read at night and put my phone on the stand, when I get up I take the phone and put the reader on the stand. I have found it works fine for for my Samsung J7 and my wife's Iphone X works also. You just have to center it on the target of the Choetech.

I made this in 2 pieces and glued the base to the holder. My Fire charges through the case but if your case is too thick then you might not get a connection.

A problem arises that you no longer have access to the micro usb connector unless you take the case off and unplug it. That was a show stopper but since I use Send-anywhere.com to move my files from my phone to
Bron
Thingiverse
Wat je nodig hebt om te printen: Gemiddeld Lage betrouwbaarheid
Waarom?
2-delige montage
Supports 1/3
Montage 1/3
Instellingen 1/3
Bedgrootte 0/3
Nabewerking 0/3
Printer
FDM / FFF
Bestandsformaat
STL
Materiaal
Software
Cura, PrusaSlicer of vergelijkbaar
Zelfde ontwerper, meer platforms

Kisssys publiceert ook op

139 extra modellen op 1 andere platforms

Geverifieerd door overeenkomende modeltitels op platforms.
Nog geen beoordelingen
Nog geen reacties – wees de eerste!

Vergelijkbare modellen

6 Suggesties
Feed Blog Slicer Kostenrekenmachine Zoeken op afbeelding Indienen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Toevoegen aan collectie