Thingiverse
Wireless DMX 3.1 enclosure
door vidx
5
Downloads
11
Likes
0
Makes
Here's my enclosure for the 3.1 Wireless DMX module widely available as bare board online.
I don't like to have the xlr directly on the housing as it sticks out too far from your lighting devices, so I prefere to use some cable, a cable gland and add 2 connectors - one for the DMX XLR in/out and one for the 5V power supply. This wey the device is hanging by the wire and not sticking out too far.
Best result is accheaved if printed with resin printers, not so good for fillaments.
other BOM used:
4x M3x10mm screw
1x M16x1.5 cable gland
1x XLR connector (F/M depends on what you need)
1x connection to 5V porew supply. I used red JST connectors.
I don't like to have the xlr directly on the housing as it sticks out too far from your lighting devices, so I prefere to use some cable, a cable gland and add 2 connectors - one for the DMX XLR in/out and one for the 5V power supply. This wey the device is hanging by the wire and not sticking out too far.
Best result is accheaved if printed with resin printers, not so good for fillaments.
other BOM used:
4x M3x10mm screw
1x M16x1.5 cable gland
1x XLR connector (F/M depends on what you need)
1x connection to 5V porew supply. I used red JST connectors.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
