Thingiverse
Wiring Guide.
von danskinn
10
Downloads
9
Likes
0
Makes
Bolt on if you want to add to existing printed part or built in if you haven't printed it yet.
Bolt on version will require an M3 x 12 or 14mm long nema screw and if you lay the part with the big hole down, it will be stronger than the integrated version. This along with Coolreactions http://www.thingiverse.com/thing:783678 cap should make for a nice install.
P.S. Why is every one installing the motors with the wires comming out the side and not up?
Bolt on version will require an M3 x 12 or 14mm long nema screw and if you lay the part with the big hole down, it will be stronger than the integrated version. This along with Coolreactions http://www.thingiverse.com/thing:783678 cap should make for a nice install.
P.S. Why is every one installing the motors with the wires comming out the side and not up?
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!