Thingiverse
Witch's Cauldron
by josen
11
Downloads
8
Likes
0
Makes
#CostumeChallenge2017
This is a witch's cauldron. You can print the support with a witch extending her hand to you to trap you. The cauldron and the support don't need print support, you only need to open the cauldron (pota.stl) and print it to a 99% of its natural size and then print the witch's support in natural size.
They are big enough for the printer that I usually use. The witch's support is 130mmx170mmx110mm. The cauldron is 100mm diameter, is perfect for keep your candies.
You decide wich is the best filling, but for the witch's support I think that its over 15% the better, for the cauldron is better 25%.
The first design was made with the cauldron rotated. This design is with the cauldron ready to print.
This is a witch's cauldron. You can print the support with a witch extending her hand to you to trap you. The cauldron and the support don't need print support, you only need to open the cauldron (pota.stl) and print it to a 99% of its natural size and then print the witch's support in natural size.
They are big enough for the printer that I usually use. The witch's support is 130mmx170mmx110mm. The cauldron is 100mm diameter, is perfect for keep your candies.
You decide wich is the best filling, but for the witch's support I think that its over 15% the better, for the cauldron is better 25%.
The first design was made with the cauldron rotated. This design is with the cauldron ready to print.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
