Witcher Steel Sword Remix

This is a remix of shoittheman's Steel Sword, its just the handle. I redesigned it to fit my needs. I made the blade out of a graphite golf club shaft, cardboard, and foam. A picture should be posted of what it looks like. Same as his, the holes are for a 3/16 dowel, I used a steel rod for it since I wanted strength, I let the ends of the steel rods poke out above the cross guard about 4-5 inches so the golf club could slide over it. The blade ended up being about 27 inches, so its book length. The hilt is about 12 to 13.
-If you would like to have a 3D printed blade, well, you would have to change his middle piece so that the holes are closer together, or just make your own blade, as his is not very well designed, in my opinion. More of a wall mount than a cosplay.
-The changes I made were making the holes closer together, and making the holes for the cross guard sides longer, and adding a half sphere on the end of them, as I saw in a picture for the sword this is based on.
-I also