WLED christmas star

This star consists of 3 different beams, which are printed in different quantities and then have to be glued together.

What do you need?
- WS2812 LEDs 6 or 18 pieces (depending on your dexterity)
I recommend starting with 6 to begin with
- ESP8266 module (ESP01 is fine) with installed WLED (https://install.wled.me/ or https://github.com/Aircoookie/WLED/releases)
- Enameled copper wire 0.25mm
- Data cable for the suspension 3x0.25mm² (https://amzn.eu/d/8BgMKOb)
- Heat shrink tubing
- Plastic adhesive (Uhu)
- Soldering iron

4-cornered beam: 18 times
3-cornered beam: 7 times
3-cornered beam with jack hole: 1 time
Christmas Star Beam Stencil: Little helper to glue the beams together in the right angle.

3-cornered beam with hole: 1 time (not needed if you print the one with jack hole)


I proceeded as follows when gluing:
Glue 8 of the square beams together to form a circle.
Then glue the two side parts together with 5 square rays each in an x-shape.
You should