Thingiverse
WLED Powered Puck / Accent Light
von mrspiffy
10
Downloads
17
Likes
0
Makes
Based on my previous WLED powered LED night light (https://www.thingiverse.com/thing:4816082), I shrunk the form factor to create a 1" x 2.5" puck light that can be stashed anywhere you need an accent light. This light is compatible with Home Assistant and the shades found on my night light page.
Update: Now includes wall mount.
Build Instructions
Three simple parts to print, the puck base needs to be printed on a raft with support. The other parts can be printed normally. A little bit of hot glue secures the LED Ring to the base and once you've fed the wires through, put a spot of glue in the hole to secure them there.
The resistor that I used for the LED ring is 330 ohms.
Flip the base over and solder your leads to the Wemos D1 using the circuit diagram provided. Make sure that the processor faces down when you do this. Once wired up, slip the D1 into the processor plate. A dab of hot glue will help secure the D1 in the plate. Now line up the notches and snap the
Update: Now includes wall mount.
Build Instructions
Three simple parts to print, the puck base needs to be printed on a raft with support. The other parts can be printed normally. A little bit of hot glue secures the LED Ring to the base and once you've fed the wires through, put a spot of glue in the hole to secure them there.
The resistor that I used for the LED ring is 330 ohms.
Flip the base over and solder your leads to the Wemos D1 using the circuit diagram provided. Make sure that the processor faces down when you do this. Once wired up, slip the D1 into the processor plate. A dab of hot glue will help secure the D1 in the plate. Now line up the notches and snap the
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
