Thingiverse
Engineering
Go to Model
WLED PSU 5v 10a
10
Downloads
6
Likes
0
Makes
This is a power supply enclosure for the Mean Well LRS-50-5 with room for an ESP32 module to control WLED interface. Included with 2 ports for power injection at the users discretion.
**ALL HARDWARE IS M3 AND M3 HEAT INSERTS ARE REQUIRED
**STEP FILES HAVE BEEN INCLUDED FOR MODIFICATION
2 versions. One uses a typical barrel jack connector which has the screw on terminals for positive and negative. The other is a barrel jack connect which screws onto the case and you must solder the wires.
It uses the power rocker sold by biqu. All links will be placed below. The prices for the project will depend on the current prices for the parts available. as of 1/11/24 the total price of the project was around 35-40 dollars on electrical components excluding LEDS.
http://tinyurl.com/LEDPowerRocker
http://tinyurl.com/GX16-3pin
http://tinyurl.com/BarrelJack-Nut
http://tinyurl.com/BarrellJack-Normal
http://tinyurl.com/ESP32-USBC
**ALL HARDWARE IS M3 AND M3 HEAT INSERTS ARE REQUIRED
**STEP FILES HAVE BEEN INCLUDED FOR MODIFICATION
2 versions. One uses a typical barrel jack connector which has the screw on terminals for positive and negative. The other is a barrel jack connect which screws onto the case and you must solder the wires.
It uses the power rocker sold by biqu. All links will be placed below. The prices for the project will depend on the current prices for the parts available. as of 1/11/24 the total price of the project was around 35-40 dollars on electrical components excluding LEDS.
http://tinyurl.com/LEDPowerRocker
http://tinyurl.com/GX16-3pin
http://tinyurl.com/BarrelJack-Nut
http://tinyurl.com/BarrellJack-Normal
http://tinyurl.com/ESP32-USBC
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
