WLED Sync Beast - Esp32 Ethernet

Here is my Quick Design for an Esp32 Ethernet case to be used with WLED. Warning! please cut the ethernet pins on the back flush of the esp32 board and put a piece of tape over it, or youll fry the ethernet chip on it! A few notes:The buttons are hard to go in, this is by design so they dont fall out, youll get it, trust me.The JST connectors are also hard to go in, they need to be pushed all the way back to their holders, when you get it you feel a snap.The Usb C board goes in at an angle, then slides forward.The esp32 Ethernet Goes in last, with the ethernet port going in first, then the module slides back into its mount, and it then gets held in place by the raised area on the lid.Everything but the usb c board should be glueless, I got lazy so use any glue you want on the usb cFirst Flash the esp32 ethernet with a serial programmer like any other espI use IO2 IO4 IO12 for the JST connectors Then connect all the 5v together, and wire one to the esp32, same with grounduse IO36 IO39 f