Slicer Discord
WO Wall Organizer – 3D-printbaar model van MakerWorld MakerWorld
Organizers

WO Wall Organizer

0 Downloads
2 Likes
0 Makes
Model downloaden
Here's a wall organizer that can be expanded infinitely without glue or screws. This model is even A1 Mini compatible. Follow the instructions: First, remove the supports. Don't forget to remove the supports where the nails will later go. After removing the supports, the board is attached with nails. Thanks to this new technology, it can be expanded infinitely. For example, you can print a wallet holder, hooks for keys, small vases for flowers or pens, and even a whiteboard panel. To create a whiteboard, stick a sheet of film over the front of the print and write your shopping list on it with a water-soluble marker. This way, you can easily erase it with felt. Simply stick a piece of felt to the back of the single hex and moisten it before each use. This allows you to use this whiteboard just like any other. I hope your room looks tidier now.<
Categorie
Organizers
Bron
MakerWorld
Gepubliceerd
Bijgewerkt
Wat je nodig hebt om te printen: Gemiddeld Lage betrouwbaarheid
Waarom?
uitgebreide nabewerking
Eendelig Hardware nodig
Supports 1/3
Montage 0/3
Instellingen 1/3
Bedgrootte 0/3
Nabewerking 2/3
Printer
FDM / FFF
Bestandsformaat
STL
Materiaal
Nabewerking
Lijmen, Hardware
Software
Cura, PrusaSlicer of vergelijkbaar
Nog geen beoordelingen
Nog geen reacties – wees de eerste!

Vergelijkbare modellen

6 Suggesties
Feed Blog Slicer Kostenrekenmachine Zoeken op afbeelding Indienen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Toevoegen aan collectie