Thingiverse
Wolf Head Accessories
por Da5hau
159
Descargas
106
Likes
0
Makes
Some Wolf head options, I made up for my Wolfspear's.
Print at 90-95% for Original, (you will need to test this on your set up)
You may need to trim to fit your figures, especially over the shoulders. (The clippers are good for this).
I use a heat gun and hold the item in tweezers. when it gets soft I mould it to the figure, hold till cold and then glue to the figure. (A bonus is you can easily sculpt the cloak to fit and add folds).
Print at 90-95% for Original, (you will need to test this on your set up)
You may need to trim to fit your figures, especially over the shoulders. (The clippers are good for this).
I use a heat gun and hold the item in tweezers. when it gets soft I mould it to the figure, hold till cold and then glue to the figure. (A bonus is you can easily sculpt the cloak to fit and add folds).
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
