Wolf Head Keychain (Pencil Topper)

In addition to remixing a full sized [Wolf Head](https://www.thingiverse.com/thing:3692238) for my son's Cub group, I made this smaller version. It is designed to be printed in one piece, angled facing up 45 degrees, so the chin prints properly. (The STL should load into Cura already at the proper angle). This print requires supports everywhere. I used tree supports. I also recommend a brim.

There is a key Ring loop at the back and a hole to be used as a pencil topper.

Note: I tried a few pencils and some seem to be slightly bigger or smaller than others. I designed it to fit the pencils I had bought for this.There will also be variations depending on your printer setup. You can compensate for minor variations with Cura's "Horizontal Expansion". If the hole is too big or to loose, try increasing your Horizontal Expansion (ex 0.05 mm). If the hole is too small and doesn't fit onto the pencil, decrease the Expansion (ex -0.05 mm). You may have to test it out a bit...

Enjoy, and