Wolfcraft Clamp Connector

This is a connector for the older Wolfcraft Multi-Fix one-hand clamps, the predecessor of the current Wolfcraft PRO clamp.

If the outer clamping jaws are removed from the clamps, this device can be used to connect two clamps together. This doubles the maximum clamping width.

Two additional M6 nuts are required, which are pressed into the connector as a counterpart to the screws.

The connector should be printed with at least 75% infill for sufficient stability.

Although I have not tested it, the connector may also work with the newer Wolfcraft PRO and Easy clamps. In this case, however, the matching screw of the Multi-Fix clamps should be used. This screw is available here: [Thing:5612024](https://www.thingiverse.com/thing:5612024)

**Update to version 2:** I recently needed the clamps to spread something instead of clamping. When I wanted to plug the connector to the other end of the clamps, I discovered that it was a few millimeters too small. Version 2 is now 8mm longe