Wolfcraft Work Table Clamp Adapter

Two pieces that turn Wolfcraft one-hand clamps into **vertical work table clamps** for all work tables with **20mm** bore holes. So it is not just limited to the Wolfcraft Master 650 table shown in the pictures, nor to specific table thickness.

**Usage:** push the lower part (wedge) fully through a table hole, then pull down the hat piece until it's fully inside the table hole, then tighten the one-hand clamp as you usually would.

**Assembly:** orientation matters! Both pieces do have an arrow that should point into the front facing direction of the clamp! I used a M5x10mm hex screw to fix the lower part (wedge) to the clamp. M5x16mm screws should work as well I guess, but haven't tested.

**Compatibility:** These adapters should fit all smaller Wolfcraft clamps like the EHZ 65-150, EHZ 65-300 and many more that do have the 14x5mm metal rods. It does not fit with the largest Wolfcraft clamps that have 20x6mm metal rods.